Quick Sleeve™ Silicone Sleeve Install Tool

Patent-Pending Tool Enables Replacement of Silicone Sleeves in Record Time.

Enercon’s New Quick Sleeve™ features an innovative use of compressed air to allow a single person to easily slide a new silicone sleeve onto a ground roll. It attaches directly to ground rolls or with the use of an included clamp.

How to use the Patent Pending Quick Sleeve Install Tool

  1. Remove Old Sleeve
  2. Connect the tool to the ground roll with four screws. (Holes are pre-drilled by Enercon on new rolls & may be added in the field on older systems.)
  3. Connect 1/4” air line to the tool & lift eye to roll
  4. Thread air line & lift chain through the new sleeve
  5. Initiate sleeve install over the tool and the ground roll
  6. Turn on compressed air supply to tool
  7. Holes in the tool allow air to lift the sleeve away from the roll to enable sliding of the sleeve down the roll
  8. Slide sleeve down the roll until the roll is covered
  9. Disconnect the lift chain and tool.
  10. Trim the roll to size
  11. Install Treater Roll back into treater station and if any air bubbles are found knead them out before corona treating

GET IN TOUCH Connect with our application experts to see how this design may benefit your operation.

How to troubleshoot films when they don’t treat the same.
TECHNICAL PAPER

Why All Films Don’t Treat The Same

Download Now!