Enercon induction cap sealers are designed for reliable and trouble-free operation. Our eJector container rejection system provides accurrate and consistent container rejection. The eJector can be integrated with any Enercon induction sealing system and controlled with data provided by either our or your inspection system.
Should you experience operating problems with your induction sealing system please use the following troubleshooting guide to help rectify any issues you may be experiencing. If your Enercon induction sealing systems is operating correctly but you are not getting an acceptable seal, please review our General Principles links on the technical support home page.
If you have questions or experience problems with your Enercon cap sealer please contact us at 262-255-6070 or via our web contact form.
| Troubleshooting Guide |
| Symptom |
- Check the input power
- Is the power switch on at the power entry module
- Check the fuse inside the power entry module
- Remove power and open the box and ensure the ribbon cable is properly connected between the display board and the ejector control board
- Contact Enercon service department for assistance
- Check the eject signal
- Check for proper inlet air pressure
- Remove power and open the box and inspect the hose connections, looking for an open hose or a kink in a hose.
- Check solenoid wiring
- Possible bad solenoid
- Contact Enercon service department for assistance
- Are the containers sliding on the conveyor?
- Is the conveyor speed changing?
- Check the "bad container" detector for proper adjustment.
- Remove input power and open the box and ensure the ribbon cable is properly connected between the display board and the eject control board
- Bad display board
- Bad eject control board
- Contact Enercon service department for assistance
|
WARNING
HIGH VOLTAGE is present within this equipment. As with any piece of electrical equipment, one should become familiar with the manual furnished before applying power. Proper connections and operation are required for safe use. FOLLOW INSTRUCTIONS for safety of personnel when operating or maintaining this equipment. |
 Enercon's eJector container rejection system.
|