To operate your Compak 2000 power supply from a remote location other than the keypad, the following must be performed.
| Note |
| The contact must be a momentary closure to operate properly. If the contact is not momentary the condition will not be able to be overridden until the initial command is removed. |
| |
| Procedure |
- Locate TB-4 inside the power supply. (See Figure 1)
- Connect a momentary control command to the correct terminal on TB-4. (See Figure 2)
- If you have any questions, contact Enercon's Service Department for assistance.
|
Drawing links on this page require Adobe Acrobat Reader. |